NEEDED:
-board 7 / 8 discs 33 (of course, to be divided in half) -2
plastic rods (always by those posters)
-a rod of iron round no wider than 2 cm (again, someone must help to pierce and cut the vinyl)
-and-Attack ... someone skilled in using flexible and drills
Once all the disks cut in half on each end of each disc created 2 cuts of 0.5 x0, 5 to almost ends of each base. Do
drill each disk to the summit and more to the center as possible!
assembaggio Well ... now!
Place the center shaft in the holes at the top of the vinyl, and at each hole, after they are well positioned,
dates a few drops of Attack.
Let dry before moving on to the next step.
Now position the two support rods of DAES disks, and for these to every engagement a bit 'for Attack settle everything. (although these two bars you could just make it less !!!!)
Wait a few seconds for drying. And the door is
cde prontisssssssssssimo!!
.... For the prox .... Any ideas for girls ... I'll try to bag some afree ... we'll see what I can combine !!!!! Hug De
....
0 comments:
Post a Comment